Enduro Pro intercom Peltor system

All the latest technology available is built into the NEW PMD Race Products ENDURO PRO intercom.

Supplied with Peltor compatiable headset leads to plug direct into Peltor compatible wired helmets (helmets not included)

Our superior noise cancelling technology and high powered 7 watt audio circuitry provides powerful clear communications from the NEW ENDURO PRO intercom.

Our Enduro Pro intercom has been designed for competitors wanting a reliable, clear intercom system with all the features needed for in-car communications. 
The Enduro Pro intercom interfaces easily to in-car radio radios (hand held or in-car units) and our transformer coupled circuitry with adjustable gain control ensures the communications via the race radio is high quality and at the correct audio levels. 
The Enduro Pro also has a transformer coupled output port for feeding driver/co-driver audio directly to your on-board video system, something not found on many other opposition intercom systems.

The Enduro Pro Peltor kit will plug into your pre-wired Peltor helmets and provide you far superior performance over your existing Peltor intercom amplifier in high noise and extreme racing conditions.

The Enduro Pro has a special audio filtering circuit on board to allow us to implement "side tone" without squealing audio back into your ear.   The use of side tone helps prevent the driver or navigator from yelling to each other and into the microphone which causes unintelligible audio as both driver and navigator can clearly hear their own voice through their own helmet speakers or earbuds.  As a result you speak clearer to each other and it results in better communication between driver and navigator and also thru to your on-board race radio.

The features keep on coming with the NEW PMD Race Products Enduro Pro, we have also included a front panel "radio transmit indicator LED" so when your race radio is in transmit mode the Enduro Pro front panel power LED indicator with illuminate RED instead of the usual BLUE power indicator so you can instantly tell whether you are transmitting via your onboard radio or have a radio stuck in transmit mode.

We also have built our Enduro Pro into a rugged off road aluminum enclosure and used elastomer gaskets and O ring seals to help seal out water and grime from getting inside.
Contruction of our Enduro pro is now done using state of the art techniques using the latest surface mounted electronic components, making it the most vibration proof intercom ever.

On the rear panel of the Enduro Pro are high grade mini TAS XLR plugs to connect the intercom to your headsets, radio interface wiring, driver and navigator press to talk (PTT) buttons and to your on-board video system.  Not only do these rear connectors provide a much neater installation in your vehicle it also makes servicing and customizing your leads a lot simpler rather than having a mass of short fly leads coming out the rear of the case.  Rear panel is also clearly marked making installation and connection a simple matter of plug and play.

Did we mention that the Enduro Pro is also dash mountable ? this makes for a very neat installation by simply slotting into or under your race car dash or overhead console. 

With our extensive experience in design and manufacturing of race communcation system over the past 20+ years we are proud to include all the features and design tricks we've discovered along the way with our latest Enduro pro intercom system.   Even our cables and headsets have been resigned and are made from kelvar reinforced copper cabling which provides superior strength and shielding from outside interference.   Nexus 4 pole plugs are used for connecting headset to the headset cables which are renown in military enviroments for their long lasting reliable use.